Here’s How You Make A Flashlight Pipe/Steamroller
If you’re ready to put your creativity to the test, it’s time to watch this video by Master Bong and make your very own flashlight pipe/steamroller.
Master Bong is back with another adventure, making a flashlight pipe/steamroller. Not only is it easy to make, but it’s also simple to smoke. Not to mention, it’s innovative. If you’re ready to put your creativity to the test, it’s time to check out the video below and make your very own two-in-one smoking device.
The flashlight pipe/steamroller
Are you an imaginative cannabis enthusiast that enjoys creating DIY smoking devices? If so, you’re in luck.
Not only will the flashlight pipe/steamroller transform your boring flashlight, but it can also be put back together for continued use.
First, you need to pick out a bowl. In the video, Master Bong chooses from various-sized sockets. Next, take your flashlight apart and remove the contents, such as the battery. Because an emergency can strike at any moment, you don’t want to damage your flashlight.
After removing the contents, it’s time to cut a hole for your bowl piece. If your flashlight has a flat part, Master Bong suggests that will work best. Of course, you don’t want to place the bowl too close to your face.
Once you have made your hole, make sure to blow out the excess plastic. Inhaling plastic is a no-no, so make sure you get rid of every little piece. Then, secure your bowl into the hole nice and tight.
Finally, it’s time to pack your bowl with your favorite bud! And if you want to go the extra mile, try putting your flashlight back together to see if it still works. Be sure to check out the video below for visual instructions.