Did you know that making a gravity bong can be easy when following the right steps? You only need a few household materials. 

Let’s look at a comprehensive guide on how to make a gravity bong.

Materials for Creating a Gravity Bong 

• A pair of scissors 
• One empty and clean two-liter plastic bottle 
• Toothpick 
• Knife 
• 4×4 inch aluminum foil

Step-by-Step Process for Creating a Gravity Bong 

1. Puncture a hole in the bottom third of the plastic bottle using a knife. 
2. Use the knife to cut off the bottom third of the bottle evenly. 
3. Place the knife on the bottle’s top and use it to puncture. Remember to maintain accuracy as you puncture the bottle for the process. 
4. Cut off the two-litre bottle using the knife. The knife should be sharp to prevent destroying the bottle as you cut it into two pieces. 
5. Unscrew all the caps off the small bottle 
6. Use a puncturing device (knife) to create a hole at the center of the cap. 7. Slide your bowl piece on the hole in the particular bottle cap 
7. Screw the bottle cap onto the other small bottle. 
8. Place your small bottle on the large bottle’s base. 

The process of making a gravity bong bowl using a small socket or glass bowl piece has become very easy. 

However, you should work hard to reduce or zero the number of hazards. With the right requirements and following the steps well, you can enjoy the best DIY gravity bong. 

Below, you’ll find a process on how to put the solid piece together:

Materials for Creating a Gravity Bong Bowl 

• Lighter 
• Sharp object or knife for puncturing 
• Plastic bottle cap
• A small glass bowl or small tapered socket 

Step-by-Step Process for Creating a DIY Gravity Bong Bowl 

1. Heat the knife of the knife or piercing object using your lighter. Please consider a heated tool for poking a hole in your plastic bottle cap. 
2. After poking the hole, widen the hole using your appropriate tool. Ensure that the hole is huge enough that allow you to slide the tapered socket to fit in snugly. Cutting the hole large enough is good if you’re lacking a socket or would like to have a glass bowl. The hole should be large enough that the stem can fit in securely. 
3. Gently melt the plastic opening that you’ve cut using your lighter. It’s an important process that helps prevent leakages and have a tight fit. 
4. Slide the tapered end of the glass bowl or socket through the whole. 
5. Allow the creation to cool before you start using it. 

You’ll be ready to smoke after completing the process of making your homemade Gravity bong. How do you use the gravity bong? It’s very easy to use this gravity bong. 

Physics will help you make good use of the bong. After constructing the piece, you can follow the following steps to enjoy a successful smoking session. 

1. Fill the large bottle base till the small bottle submerges and the waterline gets to approximately two inches on the bowl. 
2. Fill the bowl with light and bud. Ensure you get the right levels, as they guarantee you the best results. 
3. Begin to pull upwards slowly on the tinny bottle. Ensure you pull slowly and gradually to get the best returns. As you pull, the chamber should start filling with smoke. 4. Pull upwards continuously until you’ve collected the ideal amount of smoke you’d want to smoke. 
4. Unscrew the bottlecap when you’re ready. Then quickly inhale the smoke you’ve collected out of your gravity bong as you push down the smaller chamber. 

While you may enjoy using your DIY bong, it’s important to have a glass of ice water. In addition, ensure that you get some throat lozenges. 

Why are these things important? Studies show that these bongs collect more smoke than standard water pipes. Thus, smoking using a gravity bong may result in some roughness. Preparing yourself to cough in advance will be important to save you any discomfort that may arise.